We cover all of Meridian
We work on garage doors all over Meridian, off Eagle Road, near Ten Mile Road and toward Chinden Boulevard. Broken springs, frayed cables, worn rollers, bent tracks and tired openers are all part of the job, and so are new doors.
You can reach us 24/7, early mornings included. Estimates are free, and you'll hear the options and their prices before any work begins.
Big subdivisions, parts that age together
If your neighborhood went up street by street, the houses, doors and openers on your block are likely the same age. Builder-grade parts are built to a budget, and they tend to wear out on a similar schedule.
- The daily door wears first. In a two- or three-car garage, the door your family uses every day racks up cycles while the boat's door barely moves.
- Original openers slow down. Drive gears wear until the motor runs but the door doesn't move, or moves in jerks.
Car stuck inside on a workday morning?
The door won't open, the car is inside, and Eagle Road or I-84 is waiting. Look up at the spring above the door. A gap in the coil means spring replacement; a loose cable with the door hanging crooked means cable replacement, which also re-balances the door.
However late you're running, slow down. These rules keep a bad morning from getting worse:
- Take your finger off the button. If a spring has snapped, the motor has to lift the whole door on its own and can burn out, or the door can drop.
- Don't lift the door by hand. Without a working spring, it's very heavy and can slam down.
- Pull the red release cord only with the door all the way closed or a helper holding it; without spring support, it can fall fast.
- Send the kids and pets back inside, and keep clear of the door's path.
- Leave the springs and cables alone: never loosen, unwind or remove them.
Then call and tell us which door won't open, which car is behind it and where the door is sitting; an emergency like this gets priority. After the repair, the technician checks the balance, runs a sensor and auto-reverse test, and cleans up.
Opener trouble starts with the door
If your home still has the builder's opener, the springs may not have been adjusted since move-in day either. As a spring weakens, the motor hauls weight it was never meant to carry, which is why an original opener often groans, slows or quits. So we check the balance first.
If the door is sound, opener repair covers worn gears, sensors, force settings and remotes. When the motor is done, opener installation means a new Chamberlain opener off the truck, set up and tested before we leave.
